Manual

Your Audio-Video Router
7
7
Table 1: Front Panel Features
#
Feature
Function
1 IR Receiver LED The red LED illuminates when receiving signals from the Kramer infrared
remote control transmitter
2 IR Receiver Receives signals from the Kramer infrared remote control transmitter
3 Preview Monitor Displays the video routed to output 16
4
LCD
CONTROL
MENU Button Press once to display the last LCD settings (brightness, contrast, saturation,
and sharpness), each additional press scrolls through the menu items
+ Button Increases the selected setting
– Button Decreases the last setting
POWER Button Turns the LCD display on and off
5 VOLUME Knob Adjusts the audio level of the headphones
6 PHONES ¼” Connector Jack for connecting the headphones to audio 16 output
7 ALL Button Pressing ALL followed by an INPUT button, connects that input to all outputs
8 VIDEO Button When selected
1
9
actions relate to video independently from audio
OFF Button An OFF-OUT combination disconnects that output from the inputs; an OFF-
ALL combination disconnects all the outputs
10 AUDIO Button When selected
2
11
actions relate to audio independently from video
STO Button Stores the current setting in the non-volatile memory
12 AFV Button When selected actions relate to video and audio channels. Audio channels
follow the video channels, and the AFV button is illuminated
13 RCL Button Recalls a setup from the non-volatile memory
14 LCD MATRIX Display
3
Displays the selected input(s) switched to the output(s) (above or below the
corresponding OUTPUT label) and user interface messages
15 LCD STATUS Display
3
Displays the matrix status
16 OUT Buttons Select the output to which the input is switched (1 to 15)
Preview/16 connects the input to the preview monitor
17 IN Buttons Select the input to switch to the output (1 to 16)
18 MENU Button Recall and navigate the menu points for matrix setting
19 TAKE Button Used to confirm and complete setup and switching
Table 2: Rear Panel Features
#
Feature
Function
20 IN BNC Connectors Connect to the video sources
21 OUT BNC Connectors Connect to the video acceptors
22 IN Terminal Blocks Connect to the audio sources
23 OUT Terminal Blocks Connect to the audio acceptors
24
SYNC
IN BNC Connector Connect to the external video sync source
25 LOOP BNC Connector Connect to the SYNC IN connector on the next unit
26 TERM Button
Press to terminate at 75Ω or release for looping (push in to
terminate the sync line. Release when the sync line extends to
another unit)
27 EXT. (extension) KEYS Terminal
Block Connectors
Connect to an external keyboard (remote unit)
1 The VIDEO button is illuminated when the video breakaway mode is selected
2 The AUDIO button is illuminated when the audio breakaway mode is selected
3 In sections 10
and 11, the word “Displays” refers to the LCD MATRIX and STATUS displays