Owner's manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Contents
ii
8.1.4 Setup Menu—9: Delay, Setting for an Output 28
8.1.5 Setup Menu—4: store setup XX, Storing the Setup in a Preset 28
8.1.6 Setup Menu—6: recall setup XX, Recalling a Preset 29
8.2 Using the Config Menu 29
8.2.1 Config Menu—Input Signal Detection Display 30
8.2.2 Config Menu—Input Port Parameter Setting 31
8.2.3 Config Menu—Output Load Detection Display 33
8.2.4 Config Menu—Output Port Parameter Setting 34
8.2.5 Config Menu—Interface Configuration 36
8.2.6 Config Menu—Interface Reply Configuration 36
8.2.7 Config Menu—Protocol Switching 37
8.2.8 Config Menu—Store Default Setup 37
8.2.9 Config Menu—Total Matrix Reset 38
8.2.10 Config Menu—Display Firmware Versions 39
9 Configuring the Number of Installed Input and Output Ports 39
10 Installing and Using the Test Module to Troubleshoot Video Problems 40
10.1 Installing the Test Module 40
10.2 Setting the Resolution of the Generated Video 40
10.3 Setting the Pattern of the Generated Video 41
10.4 Using the Test Module to Troubleshoot Video Problems 41
10.4.1 Testing the Projector Output 42
10.4.2 Testing the Output Signal Path to the Projector 42
10.4.3 Testing the Input and Output Signal Path to the Projector 43
11 I/O Card Hardware Installation Instructions 43
12 Upgrading the VS-1616D Firmware 44
13 Technical Specifications 45
14 Default Communication Parameters 47
15 Factory Default EDID 47
15.1 DVI Input Card 47
15.2 HDCP Input Card 48
15.3 HDMI Input Card 50
15.4 HDMI plus Audio Input Card 52
15.5 DVI Dual Channel Input Card 53
15.6 DGKat Input Card 55
15.7 HDBaseT Input Card 57
15.8 VGA Input Card 59
16 Communication Protocols 60
16.1 Protocol 3000 60
16.1.1 Kramer Protocol 3000 Syntax 60
16.1.2 Device Message Format 60
16.1.3 Command Terms 61
16.1.4 Entering Commands 61
16.1.5 Command Forms 62