User Guide

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Configuring the VP-724xl via the OSD MENU Screens

Table 19 describes the User Define Measure features.

Table 19: User Define Measure Features

User Mode Setting Definitions

H Total Horizontal Total

H Start Horizontal active start point

H Active Horizontal active region

V Start Vertical active start point

V Active Vertical active region

Ch. Pump Charge pump current

Color Color format

H Freq Horizontal Frequency

V Freq Vertical Frequency

Measure Mode Select between Default and User Define

8.5.9.1 Setting an Input to a Non-standard Resolution (Example)

When connecting a source with a non-standard resolution, you have to set

your scaler to this resolution so it will correctly identify this source. The

Advanced mode lets you set up to three non-standard resolutions. To set an

input to a non-standard resolution, for example to 1100x800, do the

following:

1. Connect the source (with the non-standard resolution, in this example –

1100x800) to the appropriate input connector on your scaler and press the

appropriate INPUT SELECTOR button.

2. Connect the VIDEO OUT 1/2 HD15F connector to a video acceptor.

3. Turn the machines ON.

4. Press menu, go to Utility>Advanced> User Define Measure, and press

ENTER.

5. Scroll to Measure Mode, press ENTER and select User Define.

6. Set H Active to 1100 and V Active to 800, and set the remaining

parameters according to the input data.

7. Scroll to the Save Mode and save the new resolution.

8. Open the Information screen and check that the new resolution appears in

the Main Source line

(see Figure 43).

1 Note that for the Scaler to correctly read the input, its OCLK value should be different from that of any other defined input

of the scaler