Manual

1. Connect the power.
2. Connect the output(s) from which you want to acquire the EDID.
3. Press and hold the EDID SETUP button to select the desired EDID.
The OUT LEDs illuminate in the following cycle: OUT 1, OUT 2 and both blink (default).
4. Release the button when reaching the desired set up.
The EDID is now acquired.
Step 1: Check what’s in the box
VM-2DP Quick Start Guide
Step 2: Install the VM-2DP
Step 3: Connect the inputs and outputs
Mount the machine in a rack (using the RK-3T, RK-6T or RK-9T rack adapters) or place
on the table.
This page guides you through a basic installation and first-time use of your .
For more detailed information, see
VM-2DP
the user manual. You can download the latest
Kramer user manuals at for detailed instructions.
VM-2DP
http://www.kramerelectronics.com
It's a good idea to save the original box and packaging materials in case
your Kramer product needs to be returned to the factory for service.
Computer Graphics
Source (PC)
Always switch OFF the power on each device before connecting it to your . VM-2DP
For best results, we recommend
that you always use Kramer high-
performance cables to connect
your AV equipment to the VM-2DP.
The 1:2 DisplayPort Distributor
1 power adapter (5V DC input)
VM-2DP
4 rubber feet
1 Quick start sheet
1 User Manual
Display
Display
Step 4: Connect the power
Connect the 5V DC power adapter to the power socket and connect the adapter to the mains
electricity.
After connecting your , connect its power and then switch on the power on
each device.
VM-2DP
Step 5: Operate the VM-2DP
Acquire the EDID
To restore the default EDID, disconnect the outputs and repeat the above procedure