User manual

Defining the VM-24HC 2 Input 1:4 HDMI Distributor
5
5
4 Defining the VM-24HC 2 Input 1:4 HDMI Distributor
Figure 1 and Table 1 define the VM-24HC.
Figure 1: VM-24HC 2 Input 1:4 HDMI Distributor Rear Panel
Table 1: VM-24HC 2 Input 1:4 HDMI Distributor Front and Rear Panel Features
# Feature Function
1 IR Receiver IR signal sensor for the IR Remote Control
2 IR LED Lights yellow when the device receives an IR signal
3 POWER LED Lights green when the device receives power
4
EDID Buttons
READ
1
Press to acquire the EDID following selecting the EDID source. Press
again to indicate the EDID status
5 SELECT Press to select the EDID source (single output, Auto-Mix or default)
6 OUTPUT LEDs (1 to 4) Lights green when an output is connected and active.
LED flashes to indicate the source of the EDID acquired (see
Section
5.4) or when connecting a non-HDCP display while providing
HDCP content to the VM-24HC
7 INPUT SELECTOR Button Press to select Input 1 or 2 (see Section 5.2)
8 IN 1 LED Lights green when Input 1 is selected
IN 2 LED Lights green when Input 2 is selected
9 INPUT 1 and INPUT 2 HDMI
Connectors
Connect to the HDMI sources 1 and 2
10 OUTPUT 1 to OUTPUT 4
HDMI Connectors
Connect to the HDMI acceptors 1 to 4
11 RS-232 9-pin D-sub Port Connect to a PC/remote controller (see Section 5.2)
12 5V DC Power Connector Connect to the power adapter, center pin positive
1 Lights when configuring the EDID