Owner manual

VM-24HC - Using the VM-24HC 2 Input 1:4 HDMI Distributor

5 Using the VM-24HC 2 Input 1:4 HDMI

Distributor

The VM-24HC always displays the video output on all of the four outputs at the

same time (once they are ready to display the output) upon power up and when

switching an input (from IN 1 to IN 2 and vice versa).

This section describes:

 Selecting an Active Input (see Section 5.1)

 Connecting a PC/Controller via RS-232 (see Section 5.2)

 Acquiring the EDID (see Section 5.3)

5.1 Selecting an Active Input

but we need a note somewhere in there stating the video output will be displayed

simultaneously upon power up or introduction of new video once all output ports

are ready

To select an active input:

 Press the INPUT SELECTOR button to toggle between inputs 1 and 2

5.2 Connecting a PC/Controller via RS-232

You can connect a PC or serial controller to the VM-24HC using the RS-232

connection. Note that a null-modem adapter/connection is not required.

To connect to the VM-24HC via RS-232:

 Connect the RS-232 9-pin D-sub rear panel port on the VM-24HC unit via a

9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5

need to be connected) to the RS-232 9-pin D-sub port on your PC/controller