Manual

VM-24H - Connecting the VM-24H

5 Connecting the VM-24H

Always switch off the power to each device before connecting it to your

VM-24H. After connecting your VM-24H, connect its power and then

switch on the power to each device.

To connect the VM-24H, as illustrated in the example in Figure 3, do the following:

1. Connect the two HDMI sources, for example, a DVD player and a set top box,

to the INPUT 1 and INPUT 2 connectors, respectively.

2. Connect the HDMI OUTPUT connectors to up to 4 HDMI acceptors, using

Kramer HDMI copper cables. In this example, connect the:

 OUTPUT 1 connector to acceptor 1 (for example, a plasma display)

 OUTPUT 2 connector to acceptor 2 (for example, an LCD TV)

 OUTPUT 3 connector to acceptor 3 (for example, an LCD TV)

 OUTPUT 4 connector to acceptor 4 (for example, a plasma display)

Up to four outputs can be connected. Not all outputs need to be connected.

3. If required, connect a PC and/or controller to the RS-232 port (see

Section 6.1).

4. Connect the power cord to the mains electricity (not shown in Figure 3).

5. If required, acquire the EDID (see Section 6.3).