Owner's manual

Your VM-22H 2x1:2 HDMI Switcher/DA
5
5
4 Your VM-22H 2x1:2 HDMI Switcher/DA
Figure 1 and Table 1 define the VM-22H 2x1:2 HDMI Switcher/DA:
Figure 1: VM-22H 2x1:2 HDMI Switcher/DA
Table 1: VM-22H 2x1:2 HDMI Switcher/DA Features
#
Feature
Function
1 5V DC +5V DC connector for powering the unit
2 HDMI OUT2 Connects to the HDMI acceptor 2
3 HDMI OUT1 Connects to the HDMI acceptor 1
4 HDMI IN 2 Connects to the HDMI source 2
5 HDMI IN 1 Connects to the HDMI source 1
6 REMOTE IR The red LED illuminates when receiving signals from the Infrared remote control
transmitter
7 EDID SETUP Button Press briefly to determine the type of EDID stored in the non-volatile
memory
Press and hold to select the desired EDID setup and then release to acquire
EDID (see section
5.2)
8 IN SELECT Button Press to select the input. The relevant IN LED illuminates
9 IN 1 LED Illuminates when input 1 is selected
10 IN 2 LED Illuminates when input 2 is selected
11 OUT 1 LED Illuminates when output 1 is connected and active
1
12 OUT 2 LED Illuminates when output 2 is connected and active
1
13 ON LED Illuminates when receiving power
5 Using the VM-22H 2x1:2 HDMI Switcher/DA
This section describes how to connect the VM-22H (see section 5.1) and how
to use the EDID SETUP button (see section
5.2).
1 Also illuminates or blinks during EDID setup (see section 5.2)