User manual

VM-12HDCP - Connecting the VM-12HDCP

5 Connecting the VM-12HDCP

Always switch off the power to each device before connecting it to your

VM-12HDCP. After connecting your VM-12HDCP, connect its power

and then switch on the power to each device.

To connect the VM-12HDCP as illustrated in the example in Figure 2, do the

following:

1. Connect a DVI source (for example, a computer) to the INPUT connector.

We recommend that you always use the same color-space at the input

to reduce the transient effect while changing the input source.

2. Connect up to 12 OUTPUT connectors (not all outputs need to be connected)

to up to 12 DVI acceptors. For example:

 OUTPUT 1 connector to DVI acceptor 1 (for example, a projector)

 OUTPUT 12 connector to DVI acceptor 12 (for example, a display)

3. Connect the power cord to the mains electricity (not shown in Figure 2).

To use the VM-12HDCP, do the following:

1. Turn ON the POWER.

2. Acquire the EDID (see Section 6).