Instruction Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your VM-100CA
2
 Has looping connectors that can be used to connect to a local monitor (or
some other component video acceptor), or to create larger systems
1
 Features trimmers located on the underside that can be used to adjust the
component video Level and EQ. settings
In addition, the VM-100CA:
 Accepts a digital audio (S/PDIF) input, loops it and distributes it to 10
digital audio (S/PDIF) outputs using RCA connectors
 Accepts an unbalanced stereo audio input, loops it and distributes it to 10
unbalanced stereo audio outputs using RCA connectors
 Features audio level control for the unbalanced stereo audio output
 Is housed in a 19" 2U rack mountable enclosure, and is fed from a
100-264 VAC, 50/60 Hz, 18 VA power supply
To achieve the best performance:
 Connect only good quality connection cables, thus avoiding interference,
deterioration in signal quality due to poor matching, and elevated noise levels
(often associated with low quality cables)
 Avoid interference from neighboring electrical appliances that may
adversely influence signal quality and position your Kramer VM-100CA away
from moisture, excessive sunlight and dust
4 Your VM-100CA
Figure 1, Table 1, and Table 2 define the front and rear panels of the
VM-100CA 1:10 Video Component / Audio Distributor:
1 For example, you can connect two VM-100CA units to make a 1:20 video component / audio distributor (see section 6.2)