User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the TP-50 XGA/Audio Line Receiver – DA
8
5. If required, connect the LINE LOOP RJ-45 connector on the TP-50 to an
additional TP-50 unit
1
.
6. On the TP-50 underside:
 Adjust
2
the video output signal level and/or cable compensation
equalization level, if required
 If necessary, set the HS and VS switches
3
, on the underside
Figure 3: Component/XGA – Audio Distribution System, XGA Mode
1 Alternatively, you can connect it to an additional TP-46 unit
2 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
3 By default, both switches are set down (for normal V SYNC and H SYNC polarity)
TP-45
Component /XGA - Audio Transmitter
Long CAT 5 cable
LO
INE UT
XGA I
N
Computer
Graphics
Source
TP-50
XGA / Audio Receiver - DA
XGA O 1
UT
To next
TP-50 unit
Display 1
Display 2
AV
Receiver 2
AV
Receiver 1
To 2
Analog
OUT
nd
To 1
SPDIF
OUT
st
LI
INE
N
LL
INE OOP
VGA
Audio
VGA
VGA
Audio
Audio