User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your TP-123/TP-124
16
Table 10: TP-124 XGA/Audio/Data Line Receiver (Topside) Features
#
Feature
Function
1 12V DC +12V DC connector for powering the unit
2
AUDIO
OUT
S/PDIF RCA connector Connects to the digital audio acceptor
3 ANALOG 3.5mm mini jack Connects to the analog audio acceptor
4 RS-232 Terminal Block connector Connects to the controlled unit
5 LINE IN RJ-45 connector
Connects to
1
the LINE OUT RJ-45 connector on the TP-123 or
the TP-104
2
6 XGA OUT 15-pin HD (F) connector Connect to the XGA acceptor
7 LINK LED Illuminates when receiving the correct input signal
8 LEVEL trimmer Adjusts
4
the output signal level
9 EQ.
3
Adjusts trimmer
4
10
the cable compensation equalization level
ON LED Illuminates when receiving power
7.2.1 Your TP-124 XGA/Audio/Data Line Receiver (Underside)
Figure 12 and Table 11 define the underside
5
of the TP-124 XGA/Audio
/Data Line Receiver:
Figure 12: TP-124 XGA/Audio/Data Line Receiver (Underside
1
)
Table 11: TP-124 XGA/Audio/Data Line Receiver (Underside) Features
#
Feature
Function
1 VS Switch Slide the switch up
2
to set the V SYNC to positive polarity;
slide the switch down to set the V SYNC to negative polarity
2 HS Switch Slide the switch up
6
1 Using a UTP cable with CAT 5 connectors at both ends (the PINOUT is defined in
to set the H SYNC to positive polarity;
slide the switch down to set the H SYNC to negative polarity
Table 12 and Figure 14)
2 The TP-104 does not accept the audio signals
3 Degradation and VGA/XGA signal loss can result from using long cables (due to stray capacitance), sometimes leading to a
total loss of sharpness in high-resolution signals
4 Use a screwdriver to carefully rotate the trimmer, adjusting the appropriate level
5 The underside is identical on the TP-122 and TP-124
6 By default, both switches are set down (for a negative V SYNC and H SYNC polarity)