User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Your TP-123/TP-124

Table 8: TP-123 XGA/Audio/Data Line Transmitter Features

Feature

Function

1 12V DC +12V DC connector for powering the unit

2 AUDIO IN 3.5mm mini jack Connects to the audio source

3 RS-232 terminal block connector Connects to the PC or the Remote Controller (see section 9.1)

4 LINE OUT RJ-45 connector

Connects to

the LINE IN RJ-45 connector on the TP-124

XGA/Audio Line Receiver

XGA IN 15-pin HD (F) connector Connect to the XGA source

6 ON LED Illuminates when receiving power

7.1.1 The TP-123 Internal Polarity Switches

Figure 10 and Table 9 define the internal sync polarity switches inside the

TP-123.

Note, that you need to open the TP-123 unit to gain access to the Vs and Hs

Polarity switches. After setting the switches, close the TP-123 unit.

Figure 10: TP-123 Internal Polarity Switches

Table 9: Features of the TP-123 Internal Polarity Switches

Feature Function

VS Switch Slide the switch down

to set the V SYNC to negative polarity (NEG.);

slide the switch up to set the V SYNC to its input polarity (NORM.)

HS Switch Slide the switch down

to set the H SYNC to negative polarity (NEG.);

slide the switch up to set the H SYNC to its input polarity (NORM.)

1 Using a UTP CAT 5 cable with RJ-45 connectors at both ends (the PINOUT is defined in Table 12 and Figure 14)

2 By default, both switches are set down (for a negative V SYNC and H SYNC polarity)

NORM.

NE G.