user manual
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your WP-220E XGA/Audio/Video Line Driver
2
2 video outputs (an amplified and equalized RGBHV output on 5 BNC
connectors, and a video output 2-pin connector that connects to the coax cable
(one pin is for the composite video signal, and the other is for the Ground))
2 unbalanced stereo audio inputs (a PC audio input on a 3.5mm mini jack,
and an audio line input on left and right RCA connectors)
2 balanced stereo audio outputs (a PC audio output on a terminal block
connector, and an audio line output on a terminal block connector)
In particular, the WP-220E has:
Left and right audio level controls
EQ. control to adjust the XGA cable compensation (equalization) level
EQ., and level controls to adjust the CV cable compensation
(equalization) level
Video bandwidth of 500MHz, that ensures transparent operation for all
resolutions
A standard 12 Volt DC feed
Achieving the best performance means:
Connecting only good quality connection cables, thus avoiding
interference, deterioration in signal quality due to poor matching, and elevated
noise levels (often associated with low quality cables)
Avoiding interference from neighboring electrical appliances and
positioning your WP-220E away from moisture, excessive sunlight and dust
4 Your WP-220E XGA/Audio/Video Line Driver
This section defines the WP-220E XGA/Audio/Video Line Driver:
Available in 3 versions (see section 4.1)
Front panel (see section 4.2)
Top side panel (see section 4.3)
Lower side panel (see section 4.4)
RGBHV Outputs (see section 4.5)