user manual

Using the WP-220E XGA/Audio/Video Line Driver

5.1 Installing the WP-220E XGA/Audio/Video Line Driver

To install your WP-220E XGA/Audio/Video Line Driver:

1. Connect the 5 BNC output connectors (each is color-coded: red (R), green

(G), blue (B), yellow (Vertical Sync), and white (Horizontal Sync)) to the

pre-installed wiring in the wall box opening that connects to the XGA

acceptor (for example, a projector).

2. Connect the balanced line / PC audio out terminal block connectors (for

example, to power amplifiers) as one of the following:

Figure 7: Connect to a Balanced Acceptor

Figure 8: Connect to an Unbalanced Acceptor

3. Connect your 12V DC power supply to the POWER pins

, taking care that

polarity is correct.

4. Connect the wires of the coax cable to the VIDEO OUT pins

, taking care

that polarity is correct.

5. Insert the WP-220E directly into the wall box opening, and then mount

the front panel securely using the screws.

5.2 Operating the WP-220E XGA/Audio/Video Line Driver

To operate your WP-220E XGA/Audio/Video Line Driver:

1. Connect an XGA

source (for example, a laptop’s graphics card) to the

Input HD15F connector and to the AUDIO Input 3.5mm mini jack, for

example, using a Kramer C-GMA/GMA cable (VGA HD15M +Audio

jack to VGA HD15M +Audio jack)

1 Connect the wire labeled “+” to the +12V pin, and the wire labeled “–” to the GND pin

2 Connect the composite video wire to the VIDEO pin, and the Ground wire to the GND pin (see Figure 9)

3 Can be used for any RGBHV resolution (for example, VGA, XGA, UXGA and so on)

4 Not supplied. The complete list of Kramer cables is on our Web site at http://www.kramerelectronics.com (click “Cables

and Connectors” in the Products section)