User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Installing the RTBUS-11 Round Table Connection Bus
6
Figure 2 and Table 2 define the connecting surface:
Figure 2: RTBUS-11 Connecting Surface
Table 2: RTBUS-11 Connecting Surface Features
# Feature Function
1 RJ-45 Connector Connect to a network
2 15-pin HD Connector Connects to a VGA source
3 HDMI Connector Connect to HDMI source
4 Power Socket Connects to 110V AC power
5 3.5mm Mini Jack Connects to an unbalanced stereo audio source
6 Lid Latch For safely closing the lid
5 Installing the RTBUS-11 Round Table Connection Bus
To install the RTBUS-11 perform the following steps:
1. Drill a hole in the table (see Section
5.1).
2. Insert the unit through the hole and secure the unit to the table (see
Section
5.2).
3. Connect the cables (see Section
5.3).
5.1 Drilling a Hole in the Table
To drill an opening in the table:
1. Using any standard cup bit drill with a diameter ranging from 88mm to
90mm (3.47in to 3.55in), drill a hole in the table in the desired location.
Note: The thickness of the table should be 3in (76mm) or less.
2. Clean the table surface.
Take care not to damage the table.
Kramer Electronics is not responsible for any damage caused to the table