User manual

Install the Kramer RK-1UTB Under the Table Enclosure
7
5.3 Installing the Cables
To install the cables, do the following:
1. Connect the cables on the rear side of the unit.
2. Connect the Kramer machine (for example, the VP-100A) to the power
socket.
The RK-1UTB can accommodate 12V, 500mA, 5.2V and 2A DC power
adapters. If the machine installed requires a larger size power adapter, we
recommend using the Kramer 12V desktop power supply with a DC plug
1
3. Connect other devices to the power sockets on the front panel.
which fits easily into the rear side of the RK-1UTB enclosure.
4. Connect the rear side power socket to the mains power.
The RK-1UTB is ready for use.
5.4 Mounting Units that do not have Underside Screw Holes
Some Kramer machines do not have screw holes on the underside, which fit
the holes on the RK-1UTB. These machines (for example, the VP-5xl
2
To mount the VP-5xl on the RK-1UTB as illustrated in
) are
connected via the screw holes on the sides of the RK-1UTB.
Figure 5, do the
following:
1. Unscrew the two M3x6 screws from the side panel of the unit, which
will be attached to the side panel of the RK-1UTB.
2. Place the VP-5xl on the rack, adjacent to the inner side panel of the
RK-1UTB.
3. Insert the two M3x6 screws through the holes on the side panel of the
RK-1UTB that fit the holes on the side panel of the unit.
4. Tighten the screws.
1 P/N 2535-000635
2 A half-19" unit