User manual

Install the Kramer RK-1UTB Under the Table Enclosure
5
5 Install the Kramer RK-1UTB Under the Table Enclosure
To install the RK-1UTB you have to:
• Mount the Kramer devices on the RK-1UTB (see section
5.1)
• Attach the RK-1UTB under the table (see section
5.2)
• Install the cables (see section
5.3)
This section also describes how to:
• Mount units that do not have underside screw holes (see section
5.4)
• Connect a blank panel (optional) (see section
5.5)
5.1 Mount the Kramer devices on the RK-1UTB
The example illustrated in
Figure 1, shows the Kramer VP-100A (a half-19"
unit) with these two wall plate inserts: the WRR and W-H.
5.1.1 Installing the Required Kramer Inserts
To mount a Kramer insert or connector module, do the following:
1. Unscrew the two screws that fasten the blank plate to the connecting
surface and remove the blank plate.
2. Place the required Kramer insert over the opening, insert the two screws
to fix the Kramer insert in place, and tighten them.
5.1.2 Mounting the Kramer TOOL
The RK-1UTB underside TOOL mounting area includes a set of screw holes
that are suitable for any combination of units to be mounted.
To mount a unit on the RK-1UTB, as illustrated in
Figure 2, do the following:
1. Place the first unit on the rack (for example, the Kramer VP-100A).
2. Hold both the VP-100A and the RK-1UTB with your hands and turn
them upside down.
3. Insert the appropriate amount of screws through the holes on the
RK-1UTB that fit the holes on the underside of the VP-100A, using the
M3x5 screws supplied with the unit (as illustrated in
Figure 3).
4. Tighten the screws.
5. Rotate the RK-1UTB horizontally with the unit connected
1
1 When connecting several units (as defined in
.
Table 1), place the next unit and then repeat steps 2 to 5