User manual

Mounting on the Kramer RK-1 Rack Adapter
7
5.1 Mounting Units that do not have Underside Screw Holes
Some Kramer machines do not have screw holes on the underside, which fit
the holes on the RK-1. These machines (for example, the VP-5xl
1
or the
VA-50P
2
To mount the units on the RK-1 as illustrated in
) are connected via the screw holes on the sides of the RK-1.
Figure 3 and Figure 4
(VP-5xl and the VA-50P respectively), do the following:
1. Unscrew the two M3x6 screws from the side panel of the unit (for
example, the Kramer VP-5xl or the VA-50P), which will be attached to
the side panel of the RK-1.
2. Place the unit on the rack (for example, the Kramer VP-5xl or the
VA-50P), adjacent to the inner side panel of the RK-1.
3. Insert the two M3x6 screws through the holes on the side panel of the
RK-1 that fit the holes on the side panel of the unit (as illustrated in
Figure 3 and Figure 4).
4. Tighten the screws.
Figure 3: Mounting a half-19" unit via Screws on the RK-1 Side Panel
1 A half-19" unit
2 A 6.5” unit, see Table 2