Manual

Your RC-7B / RC-7BE
5
4.2 Defining the RC-7BE Front Panel
Figure 2 and Table 2 define the RC-7BE front panel:
Figure 2: RC-7BE Front Panel
Table 2: RC-7BE Front Panel
# Feature Function
1 Mounting holes (4) For fastening the controller in place
2 Faceplate Attachment Holes (2) For attaching the faceplate to the controller
1
3 Configurable Control Buttons (4) Macro Buttons for controlling the room and the
A/V equipment
4 CONFIG Port
2
on 3.5mm jack
connector
Used for Windows®-based configuration
software (driver downloads, firmware updates
and so on)
5
SIGNAL SOURCES Buttons
Select the input source (from 1 to 3)
6 IR IN Receiver Accepts IR remote commands (for the IR-
learner feature)
3
1 These screws should not be removed during or after mounting
2 Via the front panel, without having to remove the RC-7BE from its mounting
3 Letting you configure the RC-7BE directly from the remote transmitter without the need for software