user manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating Your VP-23RC
34
If you want to stop a macro sequence, press and hold that button for 5
seconds. The sequence will come to an end. You can resume operation by
pressing any button
1
. The unit will carry out the macro sequence commands
from the beginning.
9.3.4 Turning the Light of the Backlit Buttons On and Off
When the room is darkened, the buttons can be illuminated for convenience.
To turn on the backlight, press buttons 3 and 7 simultaneously
To turn off the backlight, press the respective buttons once again.
9.4 The Presentation Switcher Section Operation
The Presentation Switcher section has two operation modes:
 The Independent Switchers mode (see section 9.4.1)
 The Master Audio mode (see section 9.4.2)
In both operation modes, if configured, the SELECTOR buttons, once
pressed, execute a sequence of configured commands (see section 9.4.3).
9.4.1 The Independent Switchers Mode
In the independent switchers mode, the three switchers of the VP-23RC operate
independently from each other, as illustrated in Figure 20 (the Media/Room
Controller connections are not shown in this illustration). You can route one of
the 4 CV inputs, one of the 4 Y/C inputs and one of the 4 VGA/UXGA inputs to
the corresponding CV, Y/C and UXGA
2
outputs, respectively.
To switch an input to an output
3
:
 Press one
4
button from the set of four buttons in the VIDEO
(CV)-AUDIO SELECTOR section and/or
5
 One button from the set of four buttons in the s-VIDEO (Y/C)-AUDIO
SELECTOR section and/or
5
 One button from the set of four buttons in the VGA/UXGA-Audio
SELECTOR section
1 Including the button you kept pressed to stop the macro sequence
2 And to the UXGA CAT5 OUT connector (audio excluded)
3 Assuming that all inputs are connected
4 You cannot select more than one button in a section
5 You can overlook a section and choose not to select a button from it