user manual

Connecting the VP-23RC Presentation Switcher Section
15
6 Connecting the VP-23RC Presentation Switcher Section
To connect
1
the VP-23RC Presentation Switcher section, as illustrated in the
example in Figure 5, do the following
2
:
1. Connect the following video sources:
 One
3
composite video source (for example, a composite video player)
to the CV IN 1 BNC connector
 One
3
s-Video source (for example, an s-Video player) to the Y/C IN 1
4-pin connector
 One
3
VGA/UXGA source (for example, a computer graphics source)
to the UXGA IN 1 15-pin HD connector
2. Connect the acceptors to a projector
4
as follows:
 The composite video CV OUT BNC connector to the composite video
input of the projector
 The s-Video Y/C OUT 4-pin connector to the s-Video input of the
projector
 The VGA/UXGA UXGA OUT 15-pin HD connector to the
VGA/UXGA input of the projector
3. Connect the appropriate balanced
5
audio sources and acceptors (not shown in
Figure 5).
4. If required, connect the MASTER OUT terminal block connector (not shown
in Figure 5; see section 9.4.2).
5. Connect the SPKR OUT block connector to a pair of loudspeakers, by
connecting the left loudspeaker to the “L+” and the “L-” terminal block
connectors, and the right loudspeaker to the “R+” and the “R-” terminal block
connectors. Do not Ground the loudspeakers.
6. Connect the UXGA CAT5 OUT twisted pair connector (see section 6.2) to a
line receiver (for example, the TP-120 XGA Line Receiver
6
, which is
connected to a remote display).
7. If required, connect a dynamic or a condenser microphone
7
to the MIC IN XLR
connector.
1 You do not need to connect all the inputs
2 Switch OFF the power on each device before connecting it to your VP-23RC. After connecting your VP-23RC, switch on
its power and then switch on the power on each device
3 Although in this example only one source is connected, you can connect all of the four inputs, that is, 12 in total
4 In this example a projector is used, but you can also connect separate outputs such as displays or video recorders
5 To connect audio inputs and outputs, see section 6.1
6 The receiver receives the CAT 5 signal, decodes it and outputs it to a VGA acceptor
7 Use the Con / Dyn switch (refer to the rear panel, item 2 in Figure 3) to select a dynamic microphone or a condenser