User's Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Creating a Macro

5.2.2 A Relay Command – Turn Lights ON

To write a relay command on an RC button (for example, turn the lights on),

do the following:

1. Select the Relay Port (for example, RELAY_1)

2. In the RC command area, write the command description (for example, Lights

ON).

3. Select the relay command (for example, Close).

Figure 33 illustrates the RC Command area as it appears after writing the

command:

Figure 33: Lights ON RC Command

5.2.3 A Switcher Command

Use the Switcher command to select an input connected to the Kramer

SV-551 (Video 1, Video 2, PC 1, PC2 and PC 3). The switcher command

applies to the master-slave configuration only.

To write a switcher command on an RC button, do the following:

1. Select the SWITCHER Port.

2. In the RC command area, write the command description (for example,

Select).

3. Select the switcher command (for example, Video 1).

Figure 34 illustrates the RC Command area as it appears after writing the

command: