User's Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using Your WP-500
6
Figure 3: Connecting the WP-500 Front Panel
2. On the rear panel, connect the display device (for example, a projector) as
follows. Connect the:
 VGA (PC) OUTPUT to the PC Graphics (15-pin HD connector or
RGBHV connector) input on the projector
 VIDEO OUT output (VIDEO OUT, GND) to the video input on the
projector
 AUDIO OUT 1 and AUDIO OUT 2 outputs to the audio input of the
video and PC inputs on the projector
1
 RS-232 port to the PC control port of the projector and/or the IR OUT to
the IR receiver of the projector
3. Connect the ETHERNET port to a PC for configuration and control (not
shown in
Figure 4), see section 5.2.
1 You can connect either AUDIO OUT 1 or AUDIO OUT 2 to either the PC or the CV input of the projector since both audio
outputs are identical