User's Manual

VP-770 - Connecting the VP-770
13
13
6. Connect the audio input signals to the AUDIO IN connectors (3.5mm mini
jack and RCA connectors), as required (not shown in Figure 4).
7. Connect the PC VIDEO OUTPUT 15-pin HD connector to a VGA acceptor
(for example, an analog display).
8. Connect the HDMI VIDEO OUTPUT connector to an HDMI acceptor (for
example, a plasma display).
9. Connect the DGKAT RJ-45 connector to a receiver (for example, the Kramer
PT-572+).
10. Connect the SPKR Terminal Block connector to speakers (not shown in
Figure 4).
11. Connect the SPKR block connector to a pair of loudspeakers, by connecting
the left loudspeaker to the “L+” and the “L-” terminal block connectors, and
the right loudspeaker to the “R+” and the “R-” terminal block connectors. Do
not Ground the loudspeakers (not shown in Figure 4).
12. If required, you can connect a PC and/or controller to the:
 RS-232 terminal block (see Section 8.4)
 Ethernet connector (see Section 8.5)
13. Connect the power cord (not shown in Figure 4).