User's Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Connecting the VP-725XLA Presentation Switcher / Scaler

6.2 The RGBS and RGsB PINOUTs

Table 3 defines the input progressive

and interlaced

RGBS and RGsB

pinouts:

Table 3: RGBS and RGsB PINOUTS

Input Color Space PINOUT

VGA RGsB Red to PIN 1

Green + sync, to PIN 2

Blue to PIN 3

RGBS Red to PIN 1

Green to PIN 2

Blue to PIN 3

Hs (H and V) to PIN 13

YUV YPbPr Green + sync to Y

Blue to Pb

Red to Pr

6.3 Connecting to the VP-725XLA via RS-232

You can connect to the unit via a crossed RS-232 connection, using for example,

a PC. A crossed cable or null-modem is required as shown in method A and B

respectively. If a shielded cable is used, connect the shield to pin 5.

Method A (

Figure 4)—Connect the RS-232 9-pin D-sub port on the unit via a

crossed cable (pin 2 to pin 3, pin 3 to pin 2, and pin 5 to pin 5) to the RS-232 9-

pin D-sub port on the PC.

Note: There is no need to connect any other pins.

Figure 4: Crossed Cable RS-232 Connection

Hardware flow control is not required for this unit. In the rare case where a

controller requires hardware flow control, short pin 1 to 7 and 8, and pin 4 to 6

on the controller side.

Method B (

Figure 5)—Connect the RS-232 9-pin D-sub port on the unit via a

straight (flat) cable to the null-modem adapter, and connect the null-modem

adapter to the RS-232 9-pin D-sub port on the PC. The straight cable usually

1 A display mode in which all the horizontal lines of an image are displayed in a single frame (one field)

2 A display mode in which a frame consists of two separate fields with the first field consisting of odd horizontal lines and the

second field even horizontal lines