User's Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the Presentation Switcher / Scaler
16
7 Operating the Presentation Switcher / Scaler
The VP-725xl includes the following front panel buttons:
• A set of 21 INPUT SELECTOR buttons
• Video Group and Scaler Mode SELECT buttons
• A PIP button
• A FREEZE button
• A set of 7 OSD buttons (described in
Table 1): OSD ON, MENU,
ENTER, -, +, UP, and DOWN
This section describes how to:
• Switch an input to an output (see section
7.1)
• Use the PIP feature (see section
7.2)
• Lock and unlock the front panel buttons (see section
7.3)
• Freeze the image (see section
7.4)
• Display a blank screen (see section
7.5)
7.1 Switching an Input in the Video Group Mode/Scaler Mode
The VP-725xl can operate in two different modes:
• The Video Group mode, in which you can switch an input (from 1 to 4) to
an output in each of the five Video Groups: composite video, s-Video,
component video (RGB or YPbPr), HDMI and UXGA. Note that the
HDMI Group Output is momentarily lost during switch transitions in the
unit
• The Scaler mode, in which you can select one of the 21 input buttons to
switch to the scaled outputs
When the VP-725xl is in use, both modes operate simultaneously, as well as
independently. That is, the Scaler output is available even when switching in
the Video Group mode, and visa-versa.
7.2 Understanding the PIP Feature
1
The Picture-in-Picture inserter (PIP) is used for the simultaneous display of
video and graphic sources, and lets you display:
• An inserted video source
2
PIP over a graphic source
3
• An inserted graphic source
3
PIP over a video source
2
1 See section 8.1.4
2 That is, composite, s-Video
3 That is, HDMI or UXGA or component