User's Manual

FC-42 - Using the FC-42 Component To HD-SDI Converter
11
6 Using the FC-42 Component To HD-SDI
Converter
This section describes how to:
 Lock/unlock the front panel button, see Section 6.1
 Operate the FC-42, see Section 6.2
6.1 Locking the Front Panel
To prevent changing the settings accidentally or tampering with the unit via the
front panel buttons, lock your converter. Unlocking releases the protection
mechanism.
Even though the front panel is locked you can still operate via RS-232.
To lock the converter:
 Press the LOCK button for more than three seconds, until the LOCK button
is illuminated
The front panel is locked. Pressing a button has no effect other than causing
the LOCK button to flash
Warning that you need to unlock to regain control via the front panel.
To unlock the converter:
 Press the illuminated LOCK button for more than three seconds, until the
LOCK button is no longer illuminated
The front panel unlocks
6.2 Operating the FC-42 HD-SDI to Component Converter
The converter can save and load up to 16 setups via the converter menu. To use
the menu, press the:
 MENU button to start or exit the menu
 ENTER button to enter a submenu, load a setup, accept changes and reset
to the default settings
  and  buttons to scroll through the menu and sub-menus