Instruction Manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your FC-4001 Format Converter / TBC
2
 Has a looped input for synchronizing to an external source
 Has a highly stable internal generator for independent (non-genlocked)
applications
 Outputs two SDI signals, the Sync signal, and either: Component video
(Y, B-Y, and R-Y; or RGBS), or when Component video is not selected, both
Composite video and s-Video simultaneously, which is selected on dipswitches
 Lets you determine the output video standard (PAL B, PAL M, PAL N,
NTSC 3.58, NTSC 4.43, and SECAM) via the dipswitches
Note, however, that the FC-4001 does not convert between video standards.
In addition, the FC-4001 features:
 Front panel buttons for input selection (CV, Y/C, YUV, RGB/S, and
SDI), Genlock, freeze and panel lock
 Coarse trimmers and fine trimmers for adjusting the sync phase, and the
horizontal-to-subcarrier phase (SCH)
 Control via the front panel buttons; and remotely, by RS-232 serial
commands transmitted by a touch screen system, PC, or other serial controller
To achieve the best performance:
 Connect only good quality connection cables, thus avoiding interference,
deterioration in signal quality due to poor matching, and elevated noise levels
(often associated with low quality cables)
 Avoid interference from neighboring electrical appliances that may
adversely influence signal quality and position your Kramer FC-4001 away
from moisture, excessive sunlight and dust
4 Your FC-4001 Format Converter / TBC
Figure 1, Table 1, and Table 2 define the FC-4001 Format Converter / TBC.