User Manual

FC-340 - Connecting the FC-340

3. Connect the SDI OUT 2 BNC connector to an SDI acceptor (for example, an

SDI display).

4. Connect the CV ANALOG OUTPUT BNC connector to a composite video

acceptor (for example, a composite video recorder). See the Note in

Section 7.1.

5. Connect the CV 5-pin terminal block to a balanced audio acceptor (for

example, an amplifier).

6. Connect AES digital audio sources (for example, DAT players) to the

AES/3id IN 1 and IN 2 BNC connectors.

7. Connect the AES/3id OUT 1 BNC connector to an AES digital audio

acceptor (for example, a DAT recorder).

Some machines may have AES/EBU printed instead of AES-3id.

8. Optional—Connect a controller via either RS-232 or a LAN to the Ethernet

RJ-45 connector.

6.1 Connecting a Serial Controller to the FC-340

You can connect to the FC-340 via an RS-232 connection using, for example, a

PC.

To connect to the FC-340 via RS-232:

 Connect the 3-pin terminal block on the rear panel port of the FC-340 (pin G

to pin 5, pin Rx to pin 3, pin Tx to pin 2) to the RS 232 9-pin D-sub port on

your PC

6.2 Connecting to the FC-340 via Ethernet

You can connect the FC-340 via Ethernet via either of the following methods:

 A crossover cable (see Section 6.2.1) for direct connection to the PC

 A straight through cable (see Section 6.2.2) for connection via a network hub

or network router

After connecting the Ethernet port, you have to install and configure your Ethernet Port. For

detailed instructions, see the Ethernet Configuration Guide (Lantronix) in the technical support

section on our Web site http://www.kramerelectronics.com.