user manual

Using the MENU Command Sequence
37
Switcher response
changed
Current:
No reply
8.8 Setting the IR REMOTE Control
Set the IR REMOTE control to enable remote control of the VS-1616SDI
16x16 Video Matrix Switcher, using the Kramer RC-IR2 Infra-Red Remote
Control Device
1
. Refer to the RC-IR2 Infra-Red Remote Control Device user
manual
2
, for full details. Table 6 and Table 7 summarize the setup and
operational commands.
Table 6: Summary of Basic RC-IR2 Setups
To execute this command: Press the following keys in this sequence:
Allocate the VS-1616SDI to Group 12
SHIFT + GROUP + 12
Set the MACHINE #
UNIT + # key
3
(according to the VS-1616SDI dipswitch settings)
To enable IR REMOTE control (when set OFF), do the following:
1. Press the MENU button until reaching the IR REMOTE setting.
The MATRIX Display shows the message:
IR REMOTE setting
yes -> TAKE, next -> MENU
2. Press the TAKE button.
The Displays show the messages:
Outkey 1: InfraredREMOTE OFF
2: InfraredREMOTE ON
current:
remote OFF
3. Press the OUT button 2.
The TAKE LED blinks and the Displays show the messages:
Turn ON infrared REMOTE ?
Press TAKE to execute
Current:
remote OFF
4. Press the TAKE button again.
The Displays show the messages:
Infrared REMOTE mode
changed
Current:
remote ON
1 After enabling the IR REMOTE control command, remotely control the VS-1616SDI via the IR-1 remote control
transmitter pointed at the remote receiver on the VS-1616SDI’s front panel (item 1 in Figure 2)
2 Download up-to-date Kramer user manuals from our Web site at http://www.kramerelectronics.com
3 For example, press UNIT + # 1 if the VS-1616SDI is set as MACHINE # 1