Instruction Manual
Installing the single shot tray
(.177 and .22 cal. only)
To load the single shot tray into the rie, you must rst remove the magazine. Once the
breech is clear, simply align the ridge in the single shot tray with the recess in the breech
and push the tray in from the right side of the breech (g. 1). Push the tray from right to
left until it cannot be pushed further and the hole in the tray is aligned with the breech
opening and bolt pathway (g. 2).
NOTE: If you own a Puncher Pro, your rie has a rear bolt. The magazine and single shot trays are
loaded in the same manner as detailed above. Instead of pulling back on a side lever, you will lift up on
the bolt and pull it straight back. To load a magazine or single shot tray into your Puncher Pro, follow
the steps outlined above.
WARNING:
!
DO NOT INHALE DUST FROM LEAD PROJECTILES
OR PUT THEM IN YOUR MOUTH. WASH HANDS
AFTER HANDLING LEAD. LEAD PELLETS CONTAIN LEAD, A CHEMICAL KNOWN
TO THE STATE OF CALIFORNIA TO CAUSE CANCER AND BIRTH DEFECTS
(OR OTHER REPRODUCTIVE HARM).
WARNING:
!
USE THE CORRECT AMMUNITION SIZE FOR YOUR AIR
RIFLE MODEL. NEVER REUSE AMMUNITION. THE USE
OF ANY OTHER KIND OF AMMUNITION MAY CAUSE INJURY TO YOU OR DAMAGE TO
YOUR AIRGUN.
g. 1
g. 2
8