Instruction Manual

Filling the Rie
1) Attach the ll probe to the correct ll equipment. Rotate the ll port’s protective
cover to allow access (g. 1). Insert the ll adapter into the ll port (g. 2). Do not use
any other type of adapter other than the one supplied with the rie. Slowly ll the rie
to a MAXIMUM of 200 bar (approximately 2,900 psi) pressure (g. 3). Filling the rie
too fast is unsafe and creates excess heat that may result in a low or inaccurate ll
pressure. Do not overll as this will damage the gun and result in low power. Such
damage is not covered under warranty.
2) When charging is complete, bleed the excess air using the ll apparatus bleed
screw and remove the ll adapter from the rie. When nished, rotate the protective
cover to prevent contamination of the ll port (g. 4).
5
WARNING:
!
FILL YOUR PCP AIRGUN USING COMPRESSED AIR OR
NITROGEN GAS ONLY. USE OF OTHER GASES,
INCLUDING OXYGEN, CAN CAUSE A FIRE OR EXPLOSION THAT MAY RESULT IN
PROPERTY DAMAGE, SERIOUS INJURY OR DEATH.
WARNING:
!
DO NOT FILL AIRGUN WITH OXYGEN OR ANY
GAS OTHER THAN COMPRESSED AIR OR
NITROGEN GAS! FILLING WITH ANYTHING OTHER THAN AIR IS DANGEROUS
AND WILL VOID YOUR WARRANTY.
WARNING:
!
DO NOT EXCEED MAXIMUM FILL PRESSURE OF
200 bar/2,900 psi AT ROOM TEMPERATURE!
WARNING:
!
DISCONNECTING THE FILL HOSE FROM THE AIRGUN
WITHOUT FIRST BLEEDING THE AIR MAY RESULT IN
INJURY FROM HOSE WHIP DUE TO PRESSURE IN THE FILL HOSE.
DANGER
DANGER OF EXPLOSION!
Overlled compressed air cylinder
Do NOT exceed maximum ll pressure of 200 bar/ 2900 psi at room temperature!
!
g. 1
g. 3
g. 2
g. 4