Instruction Manual

To clean the rifle barrel, always open the barrel in the same way as when loading it. Use the appropriate caliber cleaning rod, rod tip, patches,
and bore brush with gun solvent and oil to clean your rifle. Insert the cleaning rod with cleaning attachments from the muzzle. You should
never use lubricating oil in the barrel.
5 - CLEANING
NEVER PUT ANY OIL INSIDE THE BARREL OR THE CHAMBER. THE RESULTING COMBUSTION COULD CAUSE
IRREPARABLE DAMAGE TO YOUR RIFLE AND SERIOUSLY HARM YOURSELF AND OTHER PEOPLE.
6 - SHOOTING ELEMENTS
Sight picture and adjustment (Figs. K-4, K-5, K-5 Page 4, according to model): Windage adjustment: If the point of impact of the shot
is to the left of the target, turn the screw 1 (see figs. K-1 or K-2, according to model) clockwise. If the point of impact of the shot is to
the right of the target, turn the screw counter-clockwise. Elevation adjustment: If the shot is too high, turn the screw 2 (see figs. K-1 or
K-2 according to model) clockwise. If the shot is too low, turn the screw counter-clockwise. Changing the position of the sight: On
some air rifles models, the sight has a part with 4 interchangeable positions. Undo the screw 3 (seefig. K-2) until the sight rotates
outside its housing. Insert the chosen shape at the top. Tighten screw 3 up again while holding the sight withyour other hand until it
slots back into the sight-holder.
K-4
K-5
4
Make sure any cleaning solvents or oils are removed from the barrel and it is dry before ring.