User's Manual

BSR100D™ Wireless Radio Modem Page 17 User Manual
5.2.1 Preparing Programming
To commence programming of the BSR100D modem
module parameters, connect the MODEM SET-UP cable
(refer to Section 3.1 Data Port Interface) to the J4
connector on the front panel of the BSR100D. The
corresponding 9-pin connection on the SET-UP cable is
connected to the PC serial COM port.
5.2.2 COM Port Settings
BSR100D programming is done through the PC’s primary
COM port. Primary and secondary COM ports are
configured with the DFP software.
The programming cable is connected from the set-up port
on the BSR100D to the PC’s COM port configured as the
primary port. The Port Setting Screen of the FPS is
accessed via the Utilities pull-down menu (see Figure 12:
DFP Software Port Setting Screens).
The Port Setting Screens are used to configure the PC’s
serial COM ports. COM port assignments are displayed in
the bottom status bar of the DFP software screen.
Figure 12: DFP Software Port Setting Screens
5.2.3 COM Port Parameters
COM Port
Selects COM Port number (COM 1-4) for primary and
secondary COM ports (see Figure 12: DFP Software Port
Setting Screens)
Baud Rate
Selects the communication speed for primary and
secondary COM ports