Alicia swing chair Assembly Manual Kozyard LLC Products © Copyright 2016 - 2019 Kozyard LLC. | All Rights Reserved.
ASEEMBLY INSTUCTION BEFORE ASSEMBLING,MAKE SURE THAT YOU LAY OUT AND IDENTIFY ALL PARTS LISTED BELOW IN THE PARTS LIST. INSTALL ON LEVEL GROUND. INSTALL NOT LESS THAN 6 FEET FROM ANY OBSTRUCTION SUCH AS FENCE, GARAGE,HOUSE, OVERHANGING BRANCHES, LAUNDRY LINES,OR ELECTRICAL WIRES. TIGHTEN ALL NUTS AND BOLTS SECURELY.ALL BOLTS SHOULD BE HAND TIGHENED BEFORE USE.NEVER USE POWER TOOLS OR EXCESSIVE FORCE DURING ASSEMBLY AND TIGHTENING OF BOLTS.
Part list LEG TUBE AX2 LEG TUBE TOP CROSS BAR BX2 CX1 LEG CROSS HANGING PIPE EX2 E1X4 SPRING HOOK HX2 CANOPY TUBE BACK LEG CROSS FX1 TOP CROSS BAR DX1 BACK LEG CROSS GX1 ARMREST SEAT & BACK FRAME CUSHION IX2 JX1 J1X1 CANOPY BOLT NX4 CANOPY TUBE KX2 LX2 MX1 BOLT BOLT BOLT BOLT OX1 PX2 QX2 RX2 BOLT BOLT SX2 TX4 BOLT UX4 NUT VX21
Part list WASHER WX21 WRENCH PLASTIC SCREW PLASTIC END CAP YX2 ZX21 ALLEN KEY
STEP -1 Connect part D and part C to build the beam using bolt Q washer W,nut V and plastic end-cap Z as shown in diagram. D C Q W V Z STEP -2 Connect part A and part B with the beam using bolt U washer W,nut V and plastic end-cap Z as shown in diagram. W V Z B B U A A Attention:Both part A should be the same side,and both part B should be in the other side.
STEP -3 Connect part E and legs (part A&B) using bolt N washer W,nut V and plastic end-cap Z as shown in diagram. W V Z N E E STEP -4 Connect part G and part F to build a connection tube for the rear foot using bolt O,washer X,nut W and plastic end-cap Z as shown in diagram.
STEP -5 Connect the rear foot tube with part B using bolt T washer W,nut V and plastic end-cap Z as shown in diagram. W V Z T F G STEP -6 Connect part I and part J using bolt R washer W,nut V and plasticend-cap Z as shown in diagram.
1.Connect part E with backseat (part J1)using bolt S,washer X,nut W and plastic end-cap Z as shown in diagram. STEP -7 Z V W E1 S Z V W STEP -8 P 2. Connect part E to armrest (part I) using bolt P,washer W,nut V and plastic end-cap Z as shown in diagram. Use part H to hook the seat to the frame.
STEP -9 Affix part K to beam using screw Y. K Y K STEP -10 Insert part L to canopy.
STEP -11 Connect Part L and Part K to support canopy. STEP -12 Put the cushion part J1 on the frame. If it rains or snows,must put away the cushion part J1.
Kozyar 10808 6th St Ste 100 Rancho Cucamonga CA 91730
