Installation Guide

12’x20’ assembly manual
Parts Required:
X2
V11
V
V23
V24
V25
V26
Z2
Z2
Z1
Z1
Z
Z
Z
Z
V12
Z
Z
Z3
V23 x2
V24 x2 V x8
V25 x2
V26 x2
V11 x2 V12 x2
Z x12
Z1 x4
Z2 x4
Z3 x2
Z4 x2
V
V V
page 15
H3 x1
Z
Z4
Step 12: Snap Bracket
Snap Bracket (Part Z, Z1, Z2, Z3, Z4) to the roof panel edges as shown in the diagram.
(with snaps facing upwards)
Tips:
1. Wearing protective gloves is recommended.
2. To prevent Z-Clips (plastic brackets) from sliding off prior to assembly, apply
double-sided adhesive tape (Part H3) to the underside (bottom) edge of the roof
panels where the brackets (Part Z, Z1, Z2, Z3, Z4) are supposed to attach.
3. You can use super glue (not included) to attach the brackets to the roof panel if
the double-sided tape doesn't work for you.