Installation Guide

Tips:
page 20
Parts Required:
(with snaps facing upwards)
X2
Z x24
Z3 x2
Z4 x2
H3 x1
10’X12’ assembly manual
Z
Z
Z3
STEP 17: Snap Brackets
Snap Bracket (Part Z, Z3, Z4) to the roof panel edges as shown in the diagram.
1. Wearing protective gloves is recommended.
2. To prevent Z-Clips (plastic brackets) from sliding off prior to assembly, apply
double-sided adhesive tape (Part H3) to the underside (bottom) edge of the roof
panels where the brackets (Part Z, Z3, Z4) are supposed to attach.
3. You can use super glue (not included) to attach the brackets to the roof panel if
the double-sided tape doesn't work for you.