Victoria 10’x12’ Gazebo Assembly Manual Kozyard LLC Products www.kozyard.com © Copyright 2016 - 2019 Kozyard LLC. | All Rights Reserved.
Safety Information WARNING: This garden house Gazebo is NOT a permanent structure and is designed for sunshade and privacy and must be used under normal weather conditions. We recommend removal of the fabric canopy in windy conditions as gazebos catch wind similar to umbrellas. You must however completely disassemble the unit prior to any severe weather conditions such as thunderstorm, hurricane, and/or heavy wind and rain.
Part list Pole Pole Beam Beam Beam Beam Corner Roof Bar Corner Roof Bar Roof Bar Roof Bar Roof Bar Roof bar Netting Roof Connector Spike Plate K1 Roof Fabric Roof Fabric Spike Rope
Allen key Screw Screw Screw
Step 1 A:Connect Connector (Part G) to Pole (Part A) using screw 1# as shown in diagram. B:Link Pole (Part A)to Pole (Part A1)using screw 1# as shown in diagram. X4 C:Attach Pole (Part A1)to Plate (Part B)using screw 1# as shown in diagram.
Step 2: Connect Beam (Part C) to Beam (Part C1) using screw 3# as shown in diagram. X2 Connect Beam (Part D) to Beam (Part D1) using screw 3# as shown in diagram.
Step 3: Connect finished Beam (Part C&Part C1) and finished Beam (Part D&Part D1) to finished poles using screw 1# as shown in diagram. D1 Attention: All the beam connecting turn must be followed as above shown in diagram.
Step 4: A: Attach Roof bar (Part H) to Roof Bar (Part E) using Screw 2# as shown in diagram. X4 H B: Insert Roof bar (Part E1) to Roof Bar (Part E) as shown in diagram. C: Insert Roof bar (Part F1) to Roof Bar (Part F) as shown in diagram.
Overall upward view 2 2 2 2 Insert roof bars to roof connector(Part J) as shown in diagram.
Step 5: A: Attach Roof bar (Part F1) or (Part F2) to finished beams using Screw 1# as shown in diagram. B: Attach Roof bar (Part E1) to finished poles using Screw 2# as shown in diagram.
Step 6: Put Roof Fabric (Part K& Part K1) to roof frame as shown in diagram.
Step 7: A:Hang Netting (Part L) on finished beams as shown in diagram.
Step 8: Measure out from post to the longest possible distance(to best use the length of the Rope (Part P) and secure Anchor (Part Q) to ground at 45 degree as shown in diagram. N At last , Make sure all of screw are fixed tightenly before use.
66 Kozyar A Mer W © Copyright 2016 - 2019 Kozyard LLC. | All Rights Reserved.
