Installation Guide

INSTALLATION INSTRUCTIONS
For Models # P802-077 (Revised Date: FEB 21, 2012)
WAR NI NG ! S H UT P OWER OFF AT F US E O R CI RC UI T BRE AKE R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
Fig. 2
MOUNTING THE FIXTURE (Fig. 1)
1. Shut off power at the circuit breaker and remove the
old fixture including the mounting hardware.
2. Carefully remove the fixture from the carton and check
that all parts are included as shown in (Fig 1).
3. Remove mounting screws (G) (Size:0.16*0.55” ) from
canopy (F). Secure mounting bracket (B) to the
junction box using mounting screws(C)
(Size:0.16*0.63” ). The side of the mounting bracket
labeled “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
4. Connect the electrical wires as shown in Fig. 2, making
sure that all wire connectors (E) are secured. If your
outlet has a ground wire (green or bare copper),
connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the
mounting plate using the green screw provided.
FINISHING THE INSTALLATION (Fig. 1)
5. Place canopy (F) onto mounting bracket (B) and
secure using mounting screws (G).
6. Install the light bulbs(I) in accordance with the fixture’s
specifications. (DO NOT EXCEED THE MAXIMUM
WATTAGE RATING). (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
7. Place the glass shade (J) on the lamp holder (H). Use
the aluminum cube (L) to fix the glass shade to the
lamp body by turning clockwise. Repeat step 6 for
each glass shade.
Your installation is now complete. Return power to the
junction box and test the fixture.
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)