Installation Guide

INSTALLATION INSTRUCTIONS
For Models # P5954 -077
READ AND SAVE THESE INSTRUCTIONS
WARNING ! SHUT P O WER OFF AT FU SE O R CI RC UI T BRE AK E R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 1
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
WARNING
 Risk of shock, do not supply power to
fixture before assembly is complete.
 Do not exceed the maximum wattage rating
MOUNTING INSTRUCTIONS
1. Shut off power at the circuit breaker and remove the
old fixture and Mounting Hardware.
2. Carefully unpack your new fixture and lay out all the
parts on a clear area. Take care not to lose any small
parts necessary for installation.
3. Remove and discard the MDF particle board from the
fixture mounting plate (B) prior to installation.
4. Position the Mounting Plate (B) on the wall, and mark
the location of the two drywall anchors (H). Pre-drill the
holes for the drywall anchors (H) and Insert the drywall
Anchors into the wall.
5. Attach the Mounting Plate (B) to the Outlet box (A)
using the two screws (C). The side of the mounting
plate marked “GND” must face out.
6. Place the Wood Screws (G) through the mounting
plate and into the drywall anchors (H) to secure the
Mounting Plate (B).
7. Pass all the electrical wires through the Mounting
bracket.
CONNECTING THE WIRES (Fig. 1)
8. Connect the electrical wires as shown in Fig. 1,
making sure that all wire connectors (F) are secured. If
your outlet has a ground wire (green or bare copper),
connect the fixture’s Ground Wire to it. Otherwise,
connect the fixture’s Ground Wire directly to the
Mounting Bracket or Reinforcement Plate using the
Green Screw provided.
FINISHING THE INSTALLATION
9. Fasten the fixture body onto mounting plate (B) using
screws (D).
10. Install 4*60w G9 Xenon Light Bulbs in accordance with
the lamp’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!). (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!)
11. Slide the glass (E) into the slots on each side of the
fixture body.
Repeat this step for each glass.
***Caution, to avoid being burned, wait for
the fixture to cool, prior to replacing the light
bulbs. ***