Installation Guide

INSTALLATION INSTRUCTIONS
For Models # P3613/P3614
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton
and check that all parts are included as
shown in the illustration.
2. Shut off power at the circuit breaker and
remove old fixture including the crossbar.
3. Install the screws (K) into crossbar (A) and
secure with hex nut (L).
4. Attach the crossbar (A) to the Outlet box in
the ceiling with two screws (B). The side of
the crossbar with “GND” marked on it and
two convex points must face out.
5.
A
t this point, connect the electrical wire as
shown in Figure 2, making sure that all wire
connectors are secured. If your outlet has a
ground wire (green or bare copper), connect
the fixture Ground Wire to it. Otherwise,
connect the fixture Ground Wire directly to
the crossbar using the Green Screw
provided.
6. Place the Canopy (C) up to the ceiling and
secure by threading the Cap Nuts (D) onto
the screws.
7. Place glass (I) into ring (J). Suspend the ring
from the fitter with rods (E).
8. Install the light bulbs (3 / 4X100W, Type A,
Medium Base) in accordance with the
fixture’s specifications. (DO NOT EXCEED
THE MAXIMUM WATTAGE RATING FOR
EVERY BULB!)
9. Install glass covers (G) and secure with cap
nuts (F) to the fitter assembly (H).
10.
A
djust height and level fixture with cable
locks in canopy.
Your installation is now complete. Return power
to the junction box and test the fixture.
J
I
E
H
G
F
L
K
Fig 1
C
D
B
A
II 370