Installation Guide

INSTALLATION INSTRUCTIONS
Item#P1465-695-L (New. 11/01/2019)
READ AND SAVE THESE INSTRUCTIONS
WARNI NG! S HUT P OWE R OFF AT F USE OR CI RCUIT BRE AKE R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Page: 1/2
Fig. 1
Fig. 3
LA-3189E
PREPARATION (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in a
clean area. Take care not to misplace any small parts
necessary for installation.
ASSEMBLING THE FIXTURE WITH CHAIN LOOP (Fig. 1&Fig. 2)
3. Screw long metal rod (J) onto the threaded nipple (I) on top of
the fixture.
4. Determine the desired hanging height and thread rods (F1, F2
and F3) to the threaded nipple of the long metal rod (J). Then
screw loop (H1) onto rod (F1). Pass the wires carefully
through each rod as you assemble.
5. Attach the quick link (G) to loop (H1) and loop (H2) on the
canopy (D). Carefully feed the wire through loop (H1), quick
link (G) and loop (H2).
6. Thread screws (A) into the pre-drilled holes in the circular
strap (B) spaced the same distance apart as the holes in the
canopy (D).
7. Attach the circular strap (B) to the junction box using mounting
screws (C) (Size: #8-32N*L0.5”). The side of the circular strap
marked “GND” must face out.
CONNECTING THE WIRES (Fig. 3)
8. Connect the electrical wires as shown in fig 3, making sure
that all wire connectors are secured. If your outlet has a
ground wire (green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s ground wire
directly to the circular strap (B) using the green screw
provided.
9. Tuck the wire connectors neatly into the ceiling junction box
and then raise the canopy (D) to the ceiling.
COMPLETING THE INSTALLATION (Fig. 1)
10. Slide canopy (D) over screws (A) and secure with knurled
knobs (E).
11. Place the glass shade (K) over metal cup (L) and secure with
three tabs (Q).
12. Secure the metal plate (O) onto the LED module by using the
screw (P).
Your installation is now complete. Return power to the junction
box and test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation
purposes only. It may or may not be identical to the fixture
purchased.
Set# A-020-A
-Circular Strap
-Ground Screw
-Mounting Screw*2
Rod# W30-1-695*1(F1)
W30-1-695*2(F2)
W30-H-695*1(F3)
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
IMPORTANT: FIXTURE SHOULD BE INSTALLED
BY A QUALIFIED ELECTRICIAN TO ENSURE
PROPER WIRING AND INSTALLATION.
G
H1
H2
E
F1
F2
J
F3
I
P
O
K
L
D
A
C
B