User Guide

Update Procedures (for Mac users)

1. Connect the microKONTROL / KONTROL49 to your computer using a USB cable.

2. Mount the “KONTROL_Updater_March_2006.dmg” by double-clicking on it, and run the

“KONTROL Updater March-2006” in the disk image by double-clicking on it. The following

window will appear.

3. Hold down the [SETTING], [MESSAGE], [EXIT], and [OCTAVE SHIFT / CURSOR >]

buttons, and then turn on the power of the microKONTROL / KONTROL49. (Note: Nothing

will appear on the microKONTROL / KONTROL49 display - don’t worry!)

The message in the window will change as follows (the following procedures and windows

are for updating the KONTROL49, but are very similar when updating the

microKONTROL).

If you use a USB bus-powered hub, or your computer can’t supply enough power to the

microKONTROL / KONTROL49, the message in the window won’t change. In this case,

please use the supplied AC adapter.

If the following message is shown, the system firmware is already up to date, and no

update is necessary. If so, you can quit the KONTROL Updater.