Operation Manual

30
Effect Parameter
DYNA (Dynamics & Preamp modeling)
TYPE (▲/▼ button) VALUE (Value Dial)
COMP1 This compressor produces consistent levels and sustain. Adjusts sensitivity.
COMP2 A compressor with an emphasized attack. (1.0...10.0)
LIMITER A limiter that makes the level more consistent.
Specify the compression ratio.
(0...10.0)
DYNAEXC This effect dynamically applies an exciter according to your Adjusts sensitivity.
picking strength. (This is especially effective when you want (0...10.0)
to give more sparkle to clean sounds.)
OVERDRY Overdrive tuned for bass. Amount of distortion.
DIST Distortion tuned for bass. (1.0...10.0)
FUZZ Fuzz tuned for bass.
PREAMP1 Preamp set to a clear tone. Adjusts tone.
PREAMP2 Preamp set to a muted tone. (0...10.0)
BALANCE Creates the sound of blending the output of two pickups.
LOWCUT Filter that cuts the unwanted low-frequency range. Adjusts frequency.
Effective for recording. (0...10.0)
FRETLES Simulates a fretless bass. Adjusts tone.(0...10.0)
SLOWATK Smoothes the attack of a bass to create a violin-like effect. Specify the attack speed.
(1.0...10.0)