Operation Manual

27
9) RENAME
Here you can specify a name for each program.
The following characters can be used: space, 0–
9, A–Z, “, ‘, ❋, +, -, /.
10) WRITE
Here you can write (store) a program that you
created.
Use the Value dial to select the writing destina-
tion (User programs only). When you do so, the
name of the program that currently occupies the
writing destination will be displayed briefly.
If you decide not to write, press the √ (or ®)
button to select a different screen.
When you press the ENTER/REC button, the
edited program will be written into memory.
When the program has been written, the LCD
will indicate “COMPLT” for approximately one sec-
ond.
Before writing an edited program into a differ-
ent program number, be sure that you do not
mind overwriting the data that is currently in that
program number. The program data that is over-
written will be lost.
It is not possible to write to a preset program.