Operation Manual

26
6) REV (Reverb Effect Modeling)
These are spatial-type effects that add spacious-
ness to the sound.
7) NR (noise reduction)
Use the Value dial to adjust the depth of the noise
reduction that is applied. Increasing this value will
produce more noise reduction. Normally you will
adjust this so that you do not hear obtrusive noise
when the strings are lightly muted.
Adjust the NR level as suitable for your bass or
pickup.
If the NR value is raised excessively, the sound
may be cut off prematurely, depending on the
device that is connected. If this occurs, reduce
the value.
8) TX (Infrared transmitter)
Use the ENTER/REC button to turn the infrared
transmitter On/Off.
The infrared transmitter setting is common to all
programs, and is remembered even when the
power is turned off.
If the infrared transmitter is left on, the battery
life will be shorter. If you are not using the infra-
red transmitter, you should turn it off.