Manual

418
Effects
Mono-Mono Serial (Mono-Mono)
109: Reverb - Gate
This effect combines a mono reverb and a gate.
f: [G]Envelope Select
f: Src
g: [G]Input Reverb Mix
g: Threshold
The “[G]Envelope Select” parameter enables you to select
whether turning the gate on and off is triggered by the input sig-
nal level or controlled directly by the modulation source. You
can select from Off to Tempo for the Src parameter to specify the
modulation source.
When “[G]Envelope Select” is set to Input, the gate is controlled
by the level of signals that are the combination of the dry sound
and the reverb sound. When the signal level exceeds the thresh-
old, the gate opens and the reverb sound is output.
Normally, set “[G]Input Reverb Mix” to Dry (the gate is con-
trolled only by the dry sound). If you wish to extend the gate
time, set the “[G]Input Reverb Mix” value higher and adjust the
“Threshold” value.
REVERB
a
[R]Reverb Time
[sec]
0.1...10.0 Sets the reverberation time
High Damp [%] 0...100
Sets the damping amount in the
high range
b
[R]Pre Delay
[msec]
0...200
Sets the delay time of the reverb
sound and gate control signal
c
[R]EQ Trim 0...100 Sets the EQ input level
Reverb Balance 0...100 Sets the reverb effect balance
d
[R]PreLEQ Fc
Low,
Mid-Low
Selects the cutoff frequency (low or
mid-low) of the low-range equalizer
Pre HEQ Fc
High,
Mid-High
Selects the cutoff frequency (high or
mid-high) of the high-range
equalizer
e
[R]PreLEQ Gain
[dB]
–15.0...+15.0 Sets the gain of Low EQ
Pre HEQ Gain
[dB]
–15.0...+15.0 Sets the gain of High EQ
GATE
f
[G]Envelope
Select
D-mod, Input
Switches between modulation
source control and input signal
control
Src Off...Tempo
Selects the modulation source that
controls the gate when Envelope
Select is set to D-mod
g
[G]Input
Reverb Mix
0...100
Sets the balance between the dry
and reverb sounds of the gate
control signal
Threshold 0...100
Sets the gate threshold level
h[G]Polarity +, –
Switches between non-invert and
invert of the gate on/off state
i
[G]Attack 1...100 Sets the attack time
Release 1...100 Sets the release time
j
Wet/Dry
Dry, 1:99...99:1,
Wet
Balance between the wet and dry
signal
Src Off...Tempo
Table , “Dynamic Modulation
sources,” on page 357
Amt –100...+100 Amount of modulation source
Left
Right
FX Amt
FX Amt
Reverb
Balance
FX Amt = 100: Mono In - Mono Out / FX Amt = 0: Stereo In - Stereo Out
+
LEQ
HEQ
EQ Trim
Reverb
Pre Delay
Envelope - Control
D-mod
Input
Envelope Select
Gate
Input Reverb Mix
Reverb
Gate
Gate+Dmpr