Operation Manual

Foot controllers |833
Calibrating the pedal and setting its
polarity
If needed, you might have to calibrate the pedals to use their full range of
values, without any ‘dead spot’. Also, this procedure allows to choose the
pedal’s polarity.
Calibrate the pedal
1 Go to the Global > Controllers > Foot page.
2 Touch the Calibration button in the area of the button to calibrate, to make
the Damper & Pedal/Footswitch Calibration dialog appear.
3 Fully press the pedal down, and while continuing to press touch the Push
button to confirm the maximum value.
4 When the following dialog appears, release the pedal.