Operation Manual

Effect parameters |789
b [O]Output Level 0…50 Sets the overdrive output level
Src Off…Tempo Selects the modulation source for
the overdrive output level
Amt –50…+50 Sets the modulation amount of the
overdrive output level
e [O]Low Cutoff [Hz] 20…1.00k Sets the center frequency for Low
EQ (shelving type)
Gain [dB] –18…+18 Sets the gain of Low EQ
f [O]Mid1 Cutoff [Hz] 300…10.00k Sets the center frequency for Mid/
High EQ 1 (peaking type)
Q 0.5…10.0 Sets the band width of Mid/High EQ 1
Gain [dB] –18…+18 Sets the gain of Mid/High EQ 1
g [O]Mid2 Cutoff [Hz] 500…20.00k Sets the center frequency for Mid/
High EQ 2 (peaking type)
Q 0.5…10.0 Sets the band width of Mid/High EQ
2
Gain [dB] –18…+18 Sets the gain of Mid/High EQ 2
MULTITAP DELAY
h [D]Tap1 Time [msec] 0.0…1360.0 Sets the Tap1 delay time
Tap1 Level 0…100 Sets the Tap1 output level
i [D]Tap2 Time [msec] 0.0…1360.0 Sets the Tap2 delay time
Feedback –100…+100 Sets the Tap2 feedback amount
j [D]High Damp [%] 0…100 Sets the damping amount in the
high range
k [D]Mt.Delay Wet/Dry Dry, 1:99…99:1,
Wet
Sets the multitap delay effect bal-
ance
Src Off…Tempo Selects the Wet/Dry modulation
source for the multitap delay
Amt –100…+100 Sets the Wet/Dry modulation
amount for the multitap delay
l Wet/Dry Dry, 1:99…99:1,
Wet
Balance between the wet and dry
signal
Src Off…Tempo See DMS (Dynamic Modulation
Source)
Amt –100…+100 Amount of modulation source